Made In Great Britain

Direct from our factory

Product Test Results

All test results published

Expert Technical Advice

Call or chat with our team

Overview

Overview ⓘ

Gloss value is how much light a finish reflects at a set angle. It is measured with a glossmeter and reported in gloss units (GU). This page explains the angles, the scale and what a figure does and does not tell you.

A gloss value tells you how shiny a cured finish is. It is a measurement of appearance, taken with an instrument, so two finishes can be compared by number and not by eye.

What the test measures

Gloss is the light a surface reflects at the mirror angle. A glossmeter shines a beam at the film at a fixed angle and measures how much comes back at the same angle on the other side.

The result is given in gloss units, written GU. The scale is set against a polished black glass standard, which is defined as 100 GU. A dead flat finish reads close to 0.

How the test is carried out

The usual method is ISO 2813. The coating is applied to a flat, smooth panel and left to cure. The glossmeter is placed on the film and several readings are taken and averaged.

The standard uses three angles.

Angle Used for
60° Most finishes. The general-purpose angle.
20° High gloss. As a guide, used when the 60° reading is above 70 GU.
85° Matt and low sheen. As a guide, used when the 60° reading is below 10 GU.

The steeper 20° angle separates very glossy finishes that all read high at 60°. The shallow 85° angle does the same for matt finishes.

How to read the result

A gloss figure means nothing without its angle. "85 GU at 60°" is a complete result. "85 gloss" is not.

Names such as matt, satin and gloss are not fixed across the industry. One maker's satin can be another's semi-gloss. Compare the GU figures, at the same angle.

What it means in use

  • Light. A high-gloss floor reflects more light back into the room.
  • Cleaning. A glossy film is smoother at the surface, so dirt has less texture to hold on to.
  • Defects. Gloss shows what is underneath. Trowel marks, pinholes and roller lines are more visible in a gloss finish than in a matt one.
  • Wear. Traffic dulls a glossy film. Walkways and turning areas lose gloss before the rest of the floor.
  • Anti-slip finishes. Aggregate breaks up the surface, so an anti-slip version reads lower than the smooth version of the same coating.

What the result does not tell you

Gloss is not a measure of durability, hardness or quality. A matt coating can outlast a gloss one.

The figure is measured on a smooth test panel. On site it depends on the substrate, the film thickness and how the coating was applied. A porous or rough surface gives a lower reading from the same tin.

Gloss also changes with age. Weathering and wear both reduce it.

On our product pages

Where a product has been tested, its page shows the result, the method and, where the method has one, the rating. Results published on this site come from internal testing to the stated method. They are given for technical reference and comparison.

If a figure you need is not shown, ask our technical team.

Leave a comment

Please note, comments need to be approved before they are published.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.